TCAR-68 Tire Repair Kit for Car ＆ Moto

Supplier Information

Product Description

Card packing/ sets

Co2 cylinder 16g/ 2pcs

Co2 cylinder cover/ 1pc

Rubber Solution 7ml/ 1pc

T-handle tire plug tool/ 1pc

T-handle screw drill/ 1pc

Tire seal 10cm x 5strips (4″)/ 1pc

Co2 connection pipe/ 1pc

Plastic adapter/ 1pc

12 cards/ Inner box

6 inner boxes/ CTN.

CUFT: 2.6’

N.W.: 17kgs

G.W.: 18kgs

1.	Before set up, make sure the switch is in the “closed” position, place the adapter on the inflator.
2.	Smaller hole attach CO2 at the bottom in clockwise direction.
3.	Attach the pipe to the tire and turn the inflator clockwise to insert air into tires with CO2 cylinder.

1.	Pull out the nail from tire.
2.	Clean the ingury with the open end insrting tool.Following the direction of the injury and twist .
3.	Times in hole inside.
4.	Feed the seal string to open end inserting tool. Also using a little of solution on the surface of seal string.
5.	Insert the tool by hand into injury through the tire from outside to inside about 1 cm. Then twist it.
	Put out the tool diresctly.

more>Related Products of this Supplier