TCAR-60 Tire Repair Kit for Car ＆ Moto

Supplier Information

Product Description

Card packing/ sets

Tire seal 10cm x 5strips(Dia. 6mm)/ 1pc

Co2 cylinder 16g/ 3pcs

T-handle open eye tool/ 1pc

T-handle screwdriver tool/ 1pc

Plastic adapter/ 1pc

Rubber solution/ 1pc

Small knief/ 1pc

Cover/ 1pc

Bag/ 1pc

10 cards/ Inner box

4 Inner boxes/ CTN.

CUFT: 3.1’

N.W.: 18kgs

G.W.: 19kgs

1.	Before set up, make sure the switch is in the “closed” position, place the adapter on the inflator.
2.	Smaller hole attach CO2 at the bottom in clockwise direction.
3.	Attach the pipe to the tire and turn the inflator clockwise to insert air into tires with CO2 cylinder.

1.	Pull out the nail from tire.
2.	Clean the injury with the open end inserting tool.Following the direction of the injury and twist.
3.	Times in hole inside.
4.	Feed the seal string to open end inserting tool. Also using a little of solution on the surface of seal string.
5.	Insert the tool by hand into injury through the tire from outside to inside about 1 cm. Then twist it.
	Put out the tool directly.

more>Related Products of this Supplier